progress

I have got the assembly done for the any angle vise done.

What I have learned:

I learned how to do limited constrains so that it will rotate only to where I want it to.

Problems:

Some of bolts and treads did not fit into the holes even though I did the same 

What I still have to do:

I have to finish the ruler thing. Also putting all the pieces on a sheet. This is what I have so far

Start Assembly

I have finished the parts and now I am putting it all together.

I still have to add the dimension parts. I'm still trying to figure it out. This is all I have to talk about.

1. I selected the Any Angle Vise
2. I picked it because i wanted more experience in mechanical CADing and I thought this would challenge me.

Any Angle Vise Progress

I Finished:

 Locking Handle

 Compound Tool Holder

Problems:

The fillets for the Locking Handle didn't work well from the dimensions given.

Working on:

 Upper Compound Member

New Pieces for Any Angle Vise:

 Clamp Plug

 Saddle

 Eccentric

Working on:

 Locking Handle

Compound Tool Holder

Done got it all put together.

And

It Works!!!!!

First Print

When I went to print it I had to many pieces. So i had to print it in two sets. When I was done I found that I had too small holes for my axles. 

Second Print

I reprinted one of the sides then printed to other, With larger holes for axles. Turns out I printed at the wrong scale when it was suppose to be 6.5 in long it was 4 in.

Third Print

I accidental did the same thing as in print two with the wrong scale.

Fourth Print

I final fixed my scaling problem and got the right pieces.